![]() ![]() ![]() I have absolutely ZERO experience with installing stuff though the command line and about everything I've tried failed. leave the monitor be so it goes back to sleep after one minute to preserve power.įor this I have to install the Linux driver for the touch screen. Via the browser, most of the settings are available then (light on/off, blinds up/down etc.) I want to use to RPi for this because of it's low power consumption and as said, all I want it to do is keep that webpage open and put the monitor in standby after one minute of not using it, so I can: I've used this monitor in the past with Windows and it works fine as a touch screen.īut now I want to use it with the RPi and basically, all it'll have to to it keep a certain web page open full screen, which links to the LAN IP address of the home automation system. See, I have an in-wall touch screen monitor ( this one : iEi ISDM-150G-USB-R11/T-R)) which works with DVI for the video signal and USB for the touch control. ![]() The reason I've bought this RPi is to function as a terminal in my home automation system. I was able to create the necessary SD card and set the keyboard to belgian keyboard through the command line without too much trouble. I've received my first Raspberry Pi last week and am now slowly taking my first baby steps with Linux and the command line. This one's especially for Mark or one of the other Linux gurus here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |